Switching inverter for 12v systems circuit diagram

This PWM control circuit provides the control pulse to the DMOS Power Switch in the flyback circuit. The output of the PWM is a pulse whose width is proportional to the input control voltage and whose repetition rate is determined by an external clock signal. 

To provide the control input to the PWM and to prevent the output voltage from soaring or sagging as the load changes the error amplifier and reference voltage complete the design. They act as the feedback loop in this control circuit much like that of a servo control system.

Switching inverter for 12v systems circuit diagram

Continue Reading..

Self switching Power Supply

This is so useful circuit for you all. because this circuit switches itself off when no load is connected across its output terminals so you can prevent from over lording and form lots of electrical problems.According to the out put of IC 7805 you can get the voltage that you want..Maximum voltage is 12v (250MA).

Continue Reading..

Simple Digital Switching System

This circuit can control any one out of 16 devices with the help of two push-to-on switches. An up/down counter acts as a master-controller for the system. A visual indication in the form of LEDs is also available.  IC1 (74LS193) is a presettable up/ down counter. IC2 and IC3 (74LS154) (1of 16 decoder/demultiplexer) perform different functions, i.e. IC2 is used to indicate the channel number while IC3 switches on the selected channel.

Digital Switching System Circuit Diagram :

Before using the circuit, press switch S1 to reset the circuit. Now the circuit is ready to receive the input clock. By pressing pressing switch S2 once, the counter advances by one count. Thus, each pressing of switch S2 enables the counter to advance by one count. Likewise, by pressing switch S3 the counter counts downwards.

The counter provides BCD output. This BCD output is used as address input for IC2 and IC3 to switch one (desired channel) out of sixteen channels by turning on the appropriate triac and the corresponding LED to indicate the selected channel.  The outputs of IC3 are passed through inverter gates (IC4 through IC6) because IC3 provides negative going pulses while for driving the triacs we need positive-going pulses. The high output of inverter gates turn on the npn transistors to drive the triacs. Diodes connected in series with triac gates serve to provide unidirectional current for the gate-drive.

Sorce : www.ecircuitslab.com/2012/08/digital-switching-system.html

Continue Reading..